p
Good quality cable, but take 2
Great shielded cable for custom rewiring of your guitar. It's of good quality and does everything it should, just as you would expect from Goldo products.
It strips easily and I had no problems with soldering.
Beware though, for some Les Paul wirings 1 meter might not be enough, so better get 2.
It strips easily and I had no problems with soldering.
Beware though, for some Les Paul wirings 1 meter might not be enough, so better get 2.
0
0
Zgłoś nadużycie
NG
Great choice for a noiseless build
I bought this cable as part of a pickup swap and rewiring job on my Squier Mustang HH. Couldn't be happier with my choice. I ended up with a really clean wiring, all the hot lines are shielded and the shielding also connects the grounds between the pots and the output jack. My guitar circuit consists of a P90 in the neck, a humbucker in the bridge, a 3-way switch, 2 volumes, 1 tone with push-pull switch for splitting the bridge humbucker. I bought 2x1m pieces to have some extra, but ended up using just 1m. My pickups were shielded from factory though, so none of the wire was used on them.
Overall I'm really satisfied with the end result - zero noise, clean wiring.
I always recommend buying extra - if you're into modding, you'll use it eventually. If not, you can give it to a friend in need :) For me this cable will be an essential part of all my future guitar mods.
Overall I'm really satisfied with the end result - zero noise, clean wiring.
I always recommend buying extra - if you're into modding, you'll use it eventually. If not, you can give it to a friend in need :) For me this cable will be an essential part of all my future guitar mods.
0
1
Zgłoś nadużycie
C
great for rewiring
My Schecter KM7 had some faulty wiring since I bought it. Signal was crackling, there was noticable humming, which only escalated with time. All problems are gone since rewired it using Switchcraft jack, Bourns push/pull pot, Switchcraft 3-way toggle switch and Göldo EL90X Cable. Quality of sound skyrocketed and all noises are gone.
1
0
Zgłoś nadużycie
A
You can't go wrong
Although it's a fairly self-explanatory item, this cable is perfectly reliable and does its job well. It's a good length to get plenty of mileage out of, and its diameter makes it easy to strip without ruining everything, as can happen...to me at least.
A good price and a safe purchase, every guitarist should at least have one of these stashed for emergencies.
A good price and a safe purchase, every guitarist should at least have one of these stashed for emergencies.
0
0
Zgłoś nadużycie
MS
Good replacement part
This article is a top choice for its price. On my circuits has always worked flawlessly. Soldering is easy and clean. It seems that resistive and capacitive losses are irrelevant, therefore the signal comes out very clean.
The costruction is sufficient for its price. Recommended for the ones who need a cheap wiring solution.
The costruction is sufficient for its price. Recommended for the ones who need a cheap wiring solution.
0
0
Zgłoś nadużycie
c
My mistake
I thought this cable had just one wire and isolation around. I intended to use it for guitar wiring.
This is made like a guitar cable - the inside wire is isolated with a white sleeve and then a bare copper wire is wrapped around it and then there is the outer black isolation.
This is made like a guitar cable - the inside wire is isolated with a white sleeve and then a bare copper wire is wrapped around it and then there is the outer black isolation.
0
0
Zgłoś nadużycie
O
They do the job
I built my first guitar and needed a cable for the electronics - this was recommended by the Thomann team and they do the job perfectly!
The guitar sounds great and I barely get any feedback.
The guitar sounds great and I barely get any feedback.
0
0
Zgłoś nadużycie
A
Good cable for the price
Pretty good cable for a low price, only issue I had with it was to get it to bend properly sometimes. I'd also order two of em just in case
0
0
Zgłoś nadużycie
T
does what it should
nice regular narrow cable, i could work with it well, easy to cut, obviosly works andthe price is also ok
the quality seems really good, i am happy with it.
the quality seems really good, i am happy with it.
0
0
Zgłoś nadużycie
p
As expected
strips easily
no problems with soldering
good quality
does everything it should
no problems with soldering
good quality
does everything it should
0
0
Zgłoś nadużycie