P
not bad but room for improvement
I bought this table microphone stand so I could do work either sitting or standing by my desk, depending on whether I would be singing or speaking.
This stand supports my microphone (a t-bone 400) with no issue and the reach is long. However, adjusting it is a bit of a pain. There are three separate joints that need to be tightened. The joint closest to the microphone is rather limited in its range of motion. Also, since all joints are hinge type joints it's not easy adjusting to get the microphone exactly where you want it. Overall it's something one can work around, it just takes time.
This stand supports my microphone (a t-bone 400) with no issue and the reach is long. However, adjusting it is a bit of a pain. There are three separate joints that need to be tightened. The joint closest to the microphone is rather limited in its range of motion. Also, since all joints are hinge type joints it's not easy adjusting to get the microphone exactly where you want it. Overall it's something one can work around, it just takes time.
2
1
Zgłoś nadużycie
S
had this for about 1 year
bought this one coas i needed a somewhat cheap boom arm for my AT2020 mic, and it works great, the arm keeps still and its somewhat easy to adjust it to your needs,
i had some problems getting the part where you fasten it to the table to stay in place, so i ended up drilling two holes from the top of the "plate" into the table, and then screw it in :D. now it wont move eaven if there was an earthquake :;D
i had some problems getting the part where you fasten it to the table to stay in place, so i ended up drilling two holes from the top of the "plate" into the table, and then screw it in :D. now it wont move eaven if there was an earthquake :;D
0
0
Zgłoś nadużycie
M
Solid sturdy build quality, no fiddly wiring or cable tidy to deal with.
Needs a good stiff tightening to your studio table. So easy to move about and push mike off side out of use. Really like the black finish, blends well with other equipment.
0
0
Zgłoś nadużycie
S
Very nice microphone arm, but the clamp is pretty weak and a bit to small for my table. The clamp can't get a good enough grip on the table which means that it can move about a little bit sometimes. Not the biggest issue but worth mentioning.
1
0
Zgłoś nadużycie
n
midrange arm
works ok, i like the subtle branding, hopefully durable, the table clamp could be better as its a bit too narrow to provide complete confidence
1
0
Zgłoś nadużycie
T
Very good compared to price!
Im going to be honest, not the best.. But compared to the price this is a steal, it it stable, but in som twists and turns quirks a bit, and doesent feel that sturdy, overall 4/5
0
0
Zgłoś nadużycie
OM
Solid Boom Arm
A very good boom arm. Stays in place and just looks amazing.
The springs in the arm are tough, so it dosent work too well with lighter mics. But most big condenser microphones with a bit of weight will work perfectly!
The springs in the arm are tough, so it dosent work too well with lighter mics. But most big condenser microphones with a bit of weight will work perfectly!
0
0
Zgłoś nadużycie
G
Solid stand
It's a very stirdy stand. the quality of the stand is great, but the xlr connectors could be better quality. Still... it's a great stand
0
0
Zgłoś nadużycie
MM
Good mic stand
I use it for podcasting and it does the job very well. It is sturdy and stable. Good piece of equipment
0
0
Zgłoś nadużycie
K
Pretty good mic arm
Super clean and minimalistic. Pretty good quality for the price, but a little too clunky.
0
0
Zgłoś nadużycie
