Doepfer A-100 B84

7

Blind Backplate

  • Panel 84TE (5V)
  • Size: 3U / 84 HP
Myynnissä vuodesta Maaliskuu 2008
Tuotenumero 114761
Myyntierä 1 kappaletta
Blank Panel Yes
Bus Cable No
Bag No
22 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Perjantai, 21.06. mennessä
1

7 Asiakkaiden arviot

3.4 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Ominaisuudet

Työnjälki

5 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
more B88 than B84
Tuntematon 21.03.2016
Received this B84 blank plate but it was oversized by 4mm (B88??); luckily I had the tools to trim to the correct size and replace the screw holes - I did not have time to send this back, and it wasn't Thomann's fault anyway.
Very surprised as all of my previous Doepfer plates fit perfect, although this is a new size so teething/quality problems?

From Doepfer\'s website :
Remark #2: The back panel cannot be used as a 84 HP blind panel at the front side of the A-100 frame. The panel is a bit longer than 84 HP to cover the rear side of the A-100G6 metal frame completely. For this purpose two 42 HP blind panels have to be used (see above).
4
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
N
Not quite 84HP!
Niallerent 29.02.2020
This is larger than 84HP but it's easy to cut down to size and re-drill holes if you need to make it smaller
Ominaisuudet
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
R
Great Service
RusperHermit 21.10.2023
Very Basic part but helped me convert an old chassis into a usable unit.
Ominaisuudet
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta